شیلد نمایشگر TFT رنگی 3.5 اینچ 320X480 برای آردوینو UNO بدون تاچ

شیلد نمایشگر TFT رنگی 3.5 اینچ 320X480 برای آردوینو UNO بدون تاچ

Product Picture

MAR3502-2.jpg MAR3502-03.jpg MAR3502-01.jpg

Product Description

Product Parameters

NameParameter
Display ColorRGB 65K color
SKUMAR3501(have touch screen)/MAR3502(have no touch screen)
Screen Size 3.5(inch)
TypeTFT
Driver ICILI9486
Resolution480*320 (Pixel)
Module Interface8-bit parallel interface
Active Area 73.44*48.96(mm)
Module PCB Size85.49*55.63(mm)
Operating Temperature-20℃~70℃
Storage Temperature-40℃~70℃
Operating Voltage5V/3.3V
Power ConsumptionTBD
Product Weight(Package containing)44g(have touch screen),55g(have no touch screen)

Interface Definition

MAR3502-20.jpg
NumberPin LabelPin Description
1LCD_RSTLCD bus reset signal, low level reset
2LCD_CSLCD bus chip select signal, low level enable
3LCD_RSLCD bus command / data selection signal,

low level: command, high level: data

4LCD_WRLCD bus write signal
5LCD_RDLCD bus read signal
6GNDPower ground
75V5V power input
83V33.3V power input, this pin can be disconnected
9LCD_D0LCD 8-bit data Bit0
10LCD_D1LCD 8-bit data Bit1
11LCD_D2LCD 8-bit data Bit2
12LCD_D3LCD 8-bit data Bit3
13LCD_D4LCD 8-bit data Bit4
14LCD_D5LCD 8-bit data Bit5
15LCD_D6LCD 8-bit data Bit6
16LCD_D7LCD 8-bit data Bit7
17SD_SSSD card SPI bus chip select signal, low level enable
18SD_DISD card SPI bus MOSI signal
19SD_DOSD card SPI bus MISO signal
20SD_SCKSD card SPI bus clock signal

Product Documentation

Connect to Arduino

无框无框
Arduino UNO direct insertion pictureArduino Mega2560 direct insertion picture


How to use on Arduino

  1. Download the Arduino test program from the Program Download column
  2. For a description of the relevant test procedures, please refer to the test program documentation in the package
  1. Plug the module directly into the Arduino development board ( Do not plug in?)
  2. After the module is plugged in, power on the Arduino board
  1. Make sure the Arduino IDE is installed on your computer (if it is not installed: Arduino IDE download URL)
  2. After installing the Arduino IDE, you need to copy the dependent library to the Arduino project directory as follows:
(1) Decompress the downloaded test package
(2) Copy the dependent libraries in the Install libraries directory in the package (shown below) to the libraries folder
of the Arduino project directory ( Don't know the Arduino project directory?
MAR2406-005.jpg
  1. Open the sample in the Example directory of the package to test, compile and download( Don't know how to compile and download?
  1. After the program is downloaded, run it directly and observe the running status. If it can be displayed normally, the program runs
successfully, as shown in the following figure (take the colligate_test test program as an example):
MAR3502-01.jpg

Program Download

Reference Materials

Common Software