CloudShell2 Case2 SmokyBlue

CloudShell2 Case2 SmokyBlue

CloudShell 2 Case2 for XU4


CloudshellCase2.jpg
DEV-NC258

The Acrylic case has new design from the original CloudShell2 
The CloudShell-2 Case2 for the ODROID-XU4 is an affordable DIY Network Attached Storage (NAS) Solution with RAID support. Like the original CloudShell, it includes a color LCD and IR receiver on the front, but adds support for USB Attached SCSI (UAS or UASP) and useful data storage technologies (RAID-0, RAID-1 and SPAN). It offers dual slots for 3.5” HDD/SSD drives. The CloudShell-2 also includes a USB 3.0 to SATA bridge (JMicron JMS561), which supports UAS and allows installation of a dual 3.5" SATA HDD/SDD storages. 
Further information is available in the WiKi. : https://wiki.odroid.com/accessory/add-on_boards/xu4_cloudshell2/cs2_assembling2
cloudshell2.pngPackage include

A. Left piece 
B. Right piece 
C. Top piece 
D. Front piece 
E. Rear piece 
F. Fan_holder piece 
G. Top_holder piece 
H. Locker piece 
I. Fan 
J. Current limit fan board 
K. USB 3.0 type A-micro B cable 
L. 15V/4A Power Supply 
M. 30Pin GPIO Ribbon Cable 
N. CloudShell2 Board 
O. 2x 10mm Truss Head 
P. 4x 10mm Pan Head 
Q. 4x 8mm female hex XU4 spacer 
R. 8x 5mm Round Head 
S. 12x 10mm Round Head 

Note!!
** 3pin Power Cord is sold separately. 
** XU4 and HDDs are not included.
** Do not apply higher than 16Volt.

Specifications

Storage
- 2 Drive Bays
- Supported size : 3.5" SATA HDD

Supported RAID Type
- Basic(PM)
- JBOD
- RAID 0
- RAID 1 

Appearance
- Color: Clear, Smoky Blue
- Size (Height x Width x Depth): 140 x 110 x 221.5 mm
- Weight: 0.64kg(without HDD)

Others
- Fan 92 mm x 92 mm (cool and quiet modes)
- IR Receiver (remote controller not included)
- 2.8" 320x240 TFT LCD
- 15V/4A Power Supply (included)





Hardware Block Diagram

cs2_hw_block.png

CLOUDSHELL 2 BOARD DETAIL

Cloudshell2Frontcomponents.jpg


320x240 TFT LCD Display example
output.png


Performance 


Local storage speed test with two WD 6TB Red NAS HDDs on Kernel 4.9 LTS with USAP driver.


Cloudshell2IORead-WritePerformance.png

Cloudshell 2 is a great choice to build you own DIY high performance Network Storage!

Cloudshell2FTPandSambaperformance.png



HDD Storage parking issue.
There is sound “clack” you can hear from the HDD when the system almost the end of power-off process.
To avoid the behavior, we strongly recommend applying this script.
https://wiki.odroid.com/odroid-xu4/troubleshooting/shutdown_script
according to your preference.