|
Ublox NEO 6M GPS HMC5883L ARDUPILOT APM 2.6 Compass Module FPV
Description:
The 3DR uBlox GPS + Compass module currently works with APM: Plane-
APM: Rover and the APM: Copter version 3.0.1 (it does not work with the
current APM:Copter 2.9.1b and earlier).
Connecting to APM 2.6
3DR uBlox GPS with Onboard Compass is compatible with APM 2.6 and
includes two cables: one 4-position cable and one
5-position-to-6-position cable. To connect the GPS module to APM 2.6-
connect the GPS port to the APM GPS port using the
5-position-to-6-position cable (use the top-entry port- not the
side-entry port)- and connect the GPS MAG port to the APM I2C port using
the 4-position cable.
Mounting the GPS module
This module permits the GPS to be mounted separately from the flight
control module so that it can have the best clear (view) of the sky and
allows the compass to be distanced from interfering magnetic fields.
When mounting the GPS+Compass module:
- Place the module on the outside of your vehicle (in an elevated
position if appropriate) with a clear view of the sky- as far as
possible from the motors and ESCs- with the arrow facing forward.
- Distance the module from DC power wiring and the batteries by at least several inches.
- Place the module clear of nearby iron containing metallic objects.
(Use nylon or non magnetic stainless steel hardware and nylon or
aluminum standoffs to mount the module).
- Twist power and ground wires where possible.
Setup in mission planner:
Note: If the GPS / Magnetometer board is mounted in its correct
direction (arrow pointing forward) and the Flight controller board is
also mounted right side up with its arrow pointing forward- the
(COMPASS_ORIENT) parameter will need to be set to (Roll 180) or “8″
because the compass is upside down under the GPS modules antenna.
- Start Mission Planner and connect your flight control board: APM or PX4 and select the “Connect” tab.
- Select the “Hardware” tab- then select the left menu “Mandatory Hardware” tab and then select the “Compass” tab.
- Select the down arrow in the compass orientation pull down item and select “ROTATION_ROLL_180″.
Note:
If the Flight controller board is put in an alternate orientation- the
Orientation (i.e. COMPASS_ORIENT parameter) should be set according to
the gps’s attitude to the flight controller. So for example if both the
Flight controller and the GPS+compass module were mounted on the bottom
of the vehicle (a ridiculous example) then you would leave the Compass
orientation as ROTATION_ROLL_180. If however you wanted to mount the
GPS+Compass right-side-up you would pick Orientation “ROTATION_NONE”
because the original rotation was Roll 180- then you add the compass
rotation which is another roll 180 = Roll 360 = no rotation.
Specification:
Weight: 21g
Size: 3.7 x 3.7cm
|
